update mechanism
The original distillation tower adds a thermal conduction mechanism. The bottom thermal conduction chamber absorbs heat, and the top thermal conduction chamber needs to dissipate heat.
The bottom provides the heat needed for the recipe, and the top provides additional time reduction (the lower the better, low gives a bonus, high gives a penalty).
It's very simple, just need two heaters and two coolers.
Cooling part
The cooler consumes 1B of water and returns 990mb. It won't work when the output is full, requiring a bit of control to avoid this. (Not needed in easy mode)
The calibrator is attached to the steel drum (or wooden drum, any container works) on the input side. The number 20 can be changed arbitrarily, but it's best not to let the container be full.
Cooler open allows fluid input from the output surface, automatic upward output.
Cooling part (no return water needed)
In the case of plenty of water, you don't need to consider backwater, just count it as one recipe consumption 2B that's it.
Easy mode can be simpler, just open the machine GUI to destroy fluid, other difficulties won't work.
heater part
Just follow the diagram to copy it, if you don't understand, you can look at another wiki (following the diagram won't go wrong x)
overall picture
The following diagram shows the structural diagram required for the heavy steam cracking naphtha formulation.
12 floors high, with a thermal conduction chamber, input chamber, and output bus at the bottom, and above are 11 output chambers and one thermal conduction chamber.
Preview of the positions of the thermal conduction chamber and input chamber (to be fixed later)
The solid mechanical block serves as the controller, and the white block is the position that cannot be replaced with an input port.